User's Manual

Chapter 25 Remote Management 213
Click Main
tenance > Remote MGMT > SSH tab to display the screen as shown.
Figure 144 Ma
intenance > Remote MGMT > SSH
The following table describes the labels in this screen.
Table 91 M
aintenance > Remote MGMT > SSH
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the De
vice. If the number is grayed
out, it is not editable.
Server Access Select the interfaces through which a computer may access the Device using this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the Device
using this service.
Select Al
l to allow any computer to access the Device using this service.
Choose Ra
nge to just allow the computers with an IP address in the range that you
specify to access the Device using this service.
Apply Click this to save your changes.
Cancel Click this to restore your pr
eviously saved settings.
25.8.1 SSH Example
This section shows an example using a graphical interface SSH client program to remotely access
the device. The configuration and connection steps are similar for most SSH client programs. Refer
to your SSH client program user’s guide.