User's Manual
Table Of Contents
- DSL-100HNU-T1 v3 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- Quick Start
- Connection Status and System Info
- WAN Setup
- Wireless
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- System Monitor
- User Account
- TR-069 Client
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Diagnostic
- Troubleshooting
- Legal Information
4
Chapter
Chapter 4 Connection Status and System Info 22
CHAPTER 4
Chapter 4
Connection Status and System
Info
4.1 Overview
After you log into the web configurator, the Connection Status screen appears. This shows the
network connection status of the Device and clients connected to it.
Use the Sys
tem Info screen to look at the current status of the device, system resources, interfaces
(LAN, WAN and WLAN), and SIP accounts. You can also register and unregister SIP accounts.
If you click Virtual De
vice on the System Info screen, a visual graphic appears, showing the
connection status of the Device’s ports. See Section 2.2.2 on page 18 for more information.
4.2 The Connection Status Screen
Use this screen to view the network connection status of the device and its clients. A warning
message appears if there is a connection problem. You can configure how often you want the
Device to update this screen in Refresh Interval.
Figure 12 Conn
ection Status: Icon View