User's Manual

Chapter 5 WAN Setup 38
5.3 The More Connections Screen
The Device allows you to configure more than one Internet access connection. To configure
additional Internet access connections click Network Setting > Broadband > More Connections.
The screen differs by the encapsulation you select. When you use the Broadband > Internet
Connection screen to set up Internet access, you are configuring the first WAN connection.
Figure 21 N
etwork Setting > Broadband > More Connections
The following table describes the labels in this screen.
MTU The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed
on an interface or connection. Enter the MTU in this field.
For ENET ENCAP, the MTU value is 1500.
For PPPoE, the MTU value is 1492.
For PPPoA and RFC 1483, the MTU is 65535.
Apply Click this to save your changes.
Cancel Click this to restore your
previously saved settings.
Advanced Setup Click this to close the A
dvanced Internet Connection section.
Table 4 Internet Connection: Advanced Setup (continued)
LABEL DESCRIPTION
Table 5 Network Setting > Broadband > More Connections
LABEL DESCRIPTION
# This is an index number indicating the numb
er of the corresponding connection.
Active This field indicates whether the connection is active or not. This field is read-only.
Node Name This is the name of the Internet connection.
VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI)
numbers configur
ed for this WAN connection.