User's Manual

Chapter 6 Wireless 70
See Section 6.10.1 on page 71 for detailed definitions of the terms listed in this scr
een.
Figure 40 Network Setting
> Wireless> Advanced
The following table describes the labels in this screen.
Table 22 Network Setting
> Wireless> Advanced
LABEL DESCRIPTION
Fragmentation
Thr
eshold
This is the maximum data fragment size that can be sent. Enter a value between 256 and
2346.
Output Power Set the output power of the Device. If there is a high density of APs in an area, decrease
the output power to reduce interference with other APs. Select one of the following:
100%, 75%, 50% or 25%.
Preamble Select a preamble type from the drop-down list menu. Choices are Lo
ng or Short.
802.11 Mode Select 80
2.11b to allow only IEEE 802.11b compliant WLAN devices to associate with the
Device.
Select 80
2.11g to allow only IEEE 802.11g compliant WLAN devices to associate with the
Device.
Select 80
2.11b+g to allow either IEEE 802.11b or IEEE 802.11g compliant WLAN devices to
associate with the Device. The transmission rate of your Device might be reduced.
Select 80
2.11n to allow only IEEE 802.11n compliant WLAN devices to associate with the
Device.
Select 80
2.11g+n to allow either IEEE 802.11g or IEEE 802.11n compliant WLAN devices to
associate with the Device. The transmission rate of the Device might be reduced when an
802.11g wireless client is associated with it.
Select 80
2.11b+g+n to allow IEEE 802.11b, IEEE 802.11g or IEEE 802.11n compliant WLAN
devices to associate with the Device. The transmission rate of the Device might be
reduced when an 802.11b or 802.11g wireless client is associated with it.
Note: The transmission rate varies depending on
the mode the wireless client uses to
associate with the Device.