User's Manual
Table Of Contents
- DSL-100HNU-T1 v3 User’s Guide
- Contents
- Introduction
- Introducing the Web Configurator
- Quick Start
- Connection Status and System Info
- WAN Setup
- Wireless
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
- Dynamic DNS
- Filter
- Firewall
- Parental Control
- Certificates
- System Monitor
- User Account
- TR-069 Client
- System
- Time Setting
- Log Setting
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Diagnostic
- Troubleshooting
- Legal Information
Chapter 7 Home Networking 92
The following figure is an overview of the Device’s file server feature. Computers A and B can acc
ess
files on a USB device (C) which is connected to the Device.
Figure 49 File
Sharing Overview
A
B
C
The Device will not be able to join the workgroup if your local area network has restrictions
set up that do not allow devices to join a workgroup. In this case, contact your network
administrator.
7.7.1 Before You Begin
Make sure the Device is connected to your network and turned on.
1 C
onnect the USB device to one of the Device’s USB ports. Make sure the Device is connected to your
network.
2 T
he Device detects the USB device and makes its contents available for browsing. If you are
connecting a USB hard drive that comes with an external power supply, make sure it is connected to
an appropriate power source that is on.
If your USB device cannot be detected by the Device, see the troubleshooting for
suggestions.