User's Manual

无锡人人行拍网络科技有限公司
6
Turn-off Does not connect with camera
Check whether the camera is
well connected.
4.1.3 Side 2 port
Figure 4.1.3.1 schematic diagram of side 2 port
[1]: Bind button, For bind the transmitter and receiver. (Both the transmitter and receiver are
required to operate simultaneously).
Press the button more than 5 seconds, 3 lights (WORL, LINK, CAM) are all turn-off, then 3 lights
flash one by one, when the LED light works well that means they are well binded. This may take
2 minutes. If the connection has not been resumed after 2 minutes, repower on both ends, and
do not need to rebind.
4.1.4 Bottom side port
Figure 4.1.4.1 schematic diagram of bottom side port
[1]: DC-12V port, For power supply, connect with 12V DC power supply.