Specifications

4.1.11
碳粒/碳油阻值测
试
Carbon / carbon
resistance test
用0.5*0.5mm线宽栅型测试板测试，500g正压力，要求碳粒阻值小于
100ohm，碳油阻值小于200ohm。
Tested with 0.5 * 0.5mm wire width, 500g positive pressure,
requiring a carbon grain resistance to less than 100 ohm, and the
carbon resistance is less than 200 ohm.
4.1.12
遥控器学习功能
可靠性
Remote control
learning
function
reliability
1、能学习各种编码格式的遥控器；
2、电压从0V调至2.2V-4.2V范围内能正常学习、发码；
3、在各种气候条件下能正常学习、发码；
4、 在长期操作下，已学习的内容不易丢失；
（只适用于带学习功能遥控器）
1. Learn the remote control of various coding formats;
2, the voltage can be accessed normally from 0V to 2.2V-4.2V.
3, can learn normally under various climatic conditions;
4. Under long-term operation, the content of the learned is not
easy to lose;
(Only available for learning-based remote control)
4.1.13
学习距离
Learning
distance
手持遥控器，发射管头对头准学习样机，能够正常学习的距离，应大于5cm
（只适用于学习功能的遥控器）
Handheld remote control, launch pipe head to the primary learning
prototype, can learn from normal, should be greater than 5cm
(Remote control for learning features)
4.1.14
学习角度
Learning angle
分布以测试遥控器和普通电视机遥控器的基点，正常实现学习功能指令时
的最大角度，水平方向左、右均应大于5度；垂直方向上、下均应大于5
度，距离>3cm
Distributed to test the base point of the remote control and
ordinary TV remote control, the maximum angle when learning
functional instructions are properly realized, the horizontal
direction is left, the right should be greater than 5 degrees;
vertical direction, lower than 5 degrees, distance> 3cm
4.2 机械性能要求 Mechanical performance requirements
编号
Numbering
类目
Class
规格
Specification
要求
Require
4.2.1
外观 –所有外观
件
Appearance - All
appearance parts
在正前方视线 30 厘米处，肉眼查看
At 30 cm in front of the front,
see the naked eye
参照我司遥控器质量规范要求
Refer to our remote
control quality standard
requirements
4.2.2
酒精测试（针对普
通漆及丝印产品）
Alcohol test
(for ordinary
用载重 500g 的实验棒（底部包裹无尘布）浸
湿 95%酒精压在试样上,以 40 次/min 的速度，
来回擦拭，测试距离 20mm 左右。测试后无掉
色、起皮，露底材现象。
喷漆、丝印 50 圈：UV、PU 漆 100 圈：
Decoction of 500 g of 500g (bottom
耐醇测试后喷油件无掉色、起皮，
不漏底材现象； 丝 印 件 无 丝印 断
笔，无擦花，清晰可见为合格。
（参照我司遥控器质量规范要
求）