Users Manual

Wuxi Weida Intelligent Electronics Co., Ltd. 无锡威达智能电子股份有限公司
10 / 14
2
、遥控器操作说明
Remote control instructions
1. 遥控器基本要求 Basic requirements for remote control
1).当连上蓝牙，遥控器发送蓝牙键值；未连接上蓝牙，则发送红外键值。
1). When Bluetooth is connected, the remote control sends the Bluetooth key value; when Bluetooth
is not connected, the infrared key value is sent.
2).指示灯：红色，每按一次按键，指示灯闪一下。
2). Indicator light: red, each time you press the button, the indicator light flashes.
3). 低电压提醒：电量低于 2.4V 时，指示灯快速闪烁，只要还在操作，就一直保持闪耀状态，当不再
对遥控器进行操作后，闪烁 5 次或闪烁 3 秒后，停止并熄灭。
3). Low voltage reminder: When the battery is lower than 2.4V, the indicator light flashes quickly, as
long as it is still in operation, it will keep flashing. When the remote control is no longer operated, it
flashes 5 times or flashes for 3 seconds and then stops And goes out.
4).配对方法：
a.同时按住“OK”+“VOL-”键 3 秒，指示灯闪烁，配对成功指示灯常亮 3 秒后熄灭。
b.没配对成功时，如果还在按 OK+VOL-键就要一直发配对广播，以便用户可以配对。
c.按一次 OK+VOL-键就要能配对成功，不要反复清除配对再配对。一次按键配对成功后可以不再
发配对广播，直到下次重新按键。
d. Connection interval＜12ms
4). Pairing method:
a. Press and hold the "OK" + "VOL-" keys at the same time for 3 seconds, the indicator light
flashes, and the pairing success indicator light is always on for 3 seconds and then goes out.
b. When the pairing is not successful, if you still press the OK+VOL- key, you must keep
sending the pairing broadcast so that the user can pair.
c. Press the OK+VOL- button once to be able to pair successfully, do not clear the pairing
repeatedly and then pair. After a key pairing is successful, the pairing broadcast can no longer
be sent until the key is pressed again next time.
d. Connection interval＜12ms
5).遥控距离：≥10m
5). Remote control distance: ≥10m
6). 蓝牙设备名称：RemoteB016
6). Bluetooth device name: RemoteB016
7).支持 OK+Back 上报功能。
7). Support OK+Back reporting .
8).支持连接蓝牙版本为 5.0 的设备
8). Support to connect to devices with Bluetooth version 5.0
9）同时按下“OK+音量+”取消蓝牙配对
9）Press "OK+Volume+" at the same time to cancel Bluetooth pairing