User's Manual

Wisen Innovation Technical Doc. No.2019 WISENMESHNET® L-Series Omni Tilt Sensor Node - User Manual
www.wisencn.com Page - 9 - of 13
a remote server. The simplest way to check the signal availability on site will be to use a mobile phone having
the same service operator as that of the Gateway;
Once the location is chosen, you are ready to deploy your WISENMESHNET® system.
5.2．Deployment Procedures
1) Open the packaging box: Take the Gateway out of the package, open its lid;
2) 2G/3G/4G modems selections: Gateway has various choices of 2G/3G/4G modems. As each of the modems can
only work in certain regions due to the large diversity of mobile network modulations. Please do talk with us to
confirm the modem availability in your area.
3) SIM Card Installation: To insert/replace the SIM card, you MUST Turn off the power!
A. As shown in the figure below, insert a sim card, and make sure it is right way around (i.e., the sim chip is
pointing downward and the cut-corner bit is pointing outward to the card slot);
B. Push the SIM card all the way into the holder until you hear a click.
Figure 4. SIM Card Insertion.
4) Antenna Installation: screw the antennas firmly onto the Gateway.
Figure 5. Mesh Antenna (left) and 2G/3G/4G Antenna (right).
5) Power on: by default, the internal battery power is in place. However, when a DC power is applied, use a
Multi-meter to check if it fits to the one stated in the Feature table (i.e., 7-32VDC at minimum 2A). Please follow