User Manual

ManualsBrandsWW Scales by Conair ManualsBody Weight ScalesBody Analysis Glass Bathroom Scale, Measures Body Fat, Body Water, Bone Mass & BMI, 4 User Memory, 400 Lbs. Capacity

FCC Markings:

Warning: Changes or modiﬁ cations to this unit not expressly approved by

the party responsible for compliance could void the user’s authority to operate

the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁ cations not expressly approved by Conair

Corporation, the manufacturer of this product and the party responsible for

compliance could void the user’s authority to operate the equipment.

Battery Notes:

• Always purchase the correct size and grade of battery most suitable for the

intended use.

When replacing the battery, make sure you dispose of the old battery in

accordance with applicable regulations. They should be disposed of in a location

speciﬁ cally designated for that purpose so they can be recycled safely and

without posing any risk for the environment. Do not burn or bury them.

3. Step on the scale barefoot with your feet aligned on the electrodes (metal strips)

on both the sides of platform. Note: you must be barefoot in order for the scale to

read your body analysis measurements.

4. The display will show your weight, body fat (BF) percentage, body water (BW)

percentage, Body Mass Index (BMI) and, bone mass value. All measurements will

display together for about 10 seconds, and then the scale turns off automatically.

NOTES

If you step on the scale before “0.0” appears, the scale will not

function properly.

Scale will show “Err” if there is improper foot contact in the body analysis

mode, for instance, when you stand on the scale with socks or shoes on.

Hard or dry skin can prevent you making proper contact with electrodes on

the surface of the scale (display shows “----”). Try applying a small amount

of moisturizer to your feet before using the scale. In the event that the scale

battery needs to be replaced, the display shows “Lo”.

Customizing Your Body Analysis Monitor

This scale can be customized for up to 4 users. While the customization process is

not difﬁ cult, it may be easiest to read all the instructions ﬁ rst to familiarize yourself

with them. Then keep the instruction manual handy as you go through the process

step by step.

Buttons: USER, SET, Up and Down arrows

1. To set your user data

Tap the scale to turn it on and wait until "0.0" appears.

2. Setting the user number

Press the “Set “button. The number “P-01” will appear and blink. Use the Up/Down

button to select a user number (P-01 to P-4). Press SET to conﬁ rm.

3. Setting the height

Next, the inch or cm symbol light up (if switch is set to lb, default is height in inches;

if switch is set to KG, default is height in cm). Press the up or down arrows to adjust

the height. Pressing and holding either the up or the down arrow will advance

numbers quickly. Press SET to accept the height. Scale enters the age setting mode.

4. Setting the age

“AGE” appears and the default age 25 ﬂ ashes. Press the up or down arrows to

adjust the age and press SET to conﬁ rm. The scale enters the gender setting mode.

5. Setting the gender

A gender icon ﬂ ashes. Press the up or down arrows to choose between male

and female gender.

6. Displaying and storing data

Once gender is set, data storage is complete. Scale will display your stored data:

User number, Height, Age and Gender will each show for a few seconds.

7. The scale will display “0.0”. You may press the “Set” button to set (revise) the user

data again, or set user data for other users; you could also step on the scale to do a

body analysis directly (see the following instructions about body analysis).

Body Analysis

1. Operate the scale on a secure ﬂ at ﬂ oor. Tap the scale to turn it on, and wait till

“0.0” appears. Press the “User” button repeatedly until your user number shows on

the display.

2. Stored data for your user number appears (User number, Height, and Age) then

the scale displays “0.0”.

LIMITED TEN YEAR WARRANTY

(U.S. & CANADA ONLY)

Conair will repair or replace, at our option, your appliance free of charge for 120

months from the date of purchase if the appliance is defective in workmanship

or materials.

To obtain service under this warranty, return the defective product to the service

center listed below, together with your sales slip and $5.00 for postage and handling.

California residents need only provide proof of purchase and should call

1-800-3-CONAIR for shipping instructions. In the absence of a receipt, the warran-

ty period shall be 120 months from the date of manufacture.

ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT

LIMITED TO THE IMPLIED WARRANTY OF MERCHANT ABILI TY AND FITNESS FOR

A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 120-MONTH

DURATION OF THIS WRITTEN, LIMITED WARRANTY.

Some states do not allow

limitations on how long an implied warranty lasts, so the above limitations may not

apply to you.

IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR

CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY,

EXPRESS OR IMPLIED, WHATSOEVER.

Some states do not allow the exclusion

or limitation of special, incidental, or consequential damages, so the above

limitation may not apply to you. This warranty gives you specific legal rights,

and you may also have other rights which vary from state to state.

Please register this product at: www.conair.com/registration

Spanish translation available on our website: www.conairscales.com

Instructions for use

To get the greatest benefit from your purchase,

please read this entire brochure before using your scale.

WW702XF

body

analysis scale

WW Logo is the trademark of WW International, Inc. and is used under license by

19AD062974

IB-16425

Service Centers

Conair Corporation

Service Department

150 Milford Road

East Windsor, NJ 08520

Conair Corporation

Service Department

7475 N. Glen Harbor Blvd.

Glendale, AZ 85307

ww702xf_19ad062974_ib_final.indd 1-6ww702xf_19ad062974_ib_final.indd 1-6 5/21/19 3:05 PM5/21/19 3:05 PM

Summary of content (2 pages)

PAGE 1
Customizing Your Body Analysis Monitor This scale can be customized for up to 4 users. While the customization process is not difﬁcult, it may be easiest to read all the instructions ﬁrst to familiarize yourself with them. Then keep the instruction manual handy as you go through the process step by step. 5. Setting the gender A gender icon ﬂashes. Press the up or down arrows to choose between male and female gender. 3.
PAGE 2
Weight and Body Fat BMI – What Is It? How does it work? While body fat can be measured in many ways, the method used in your scale is bioelectrical impedance. This indirect method of determining body fat starts when a safe and very low electrical current is sent through the lower half of the body. The electrical current flows more quickly through water and muscle than it will through bone and fat. The scale measures the speed of the current.