Specifications

21
Fixture Physical Setup
Mounting and Adjusting Fixture
Adjusting the C-clamp
•
Connect a C-clamp to the yoke with the yoke bolt and washer.
•
Hang C-clamp on mounting pipe and secure with the C-clamp pipe bolt.
•
Connect the safety cable to the mounting pipe.
•
Cygnus can be rotated to the desired position by loosening the pan screw,
setting the position, and tightening the pan screw to hold the
position.! !
Attaching Accessories to the Front Holder
Cygnus Variable White 200W can accept up to two standard 7.5” accessories. The
VNS100 and MFS100 can accept one 5.75” accessory. Accessories are safely held
in place with a standard spring-loaded latch.
•
From the rear of the fixture, pull the accessory ring toward you.
•
Load the accessory into the accessory slot in the front of the Cygnus, then
release the ring.
•
The plunger will return to the initial position and hold the accessory in place.
Connecting AC Power
⚠ CAUTION: Be sure the fixture is properly grounded.
Use a good source of AC power that complies with local building and electrical
codes and has both overload and ground fault protection.
Input power must be 100-240VAC, 50/60Hz.