Specifications

22
Changing the Lenses
Instructions for changing VN or MF lens assembly:
•
!!Position the unit so the front is facing you with the filter pin on the top (12
o'clock position)
• Use a #2 phillips screwdriver to remove the seven screws from the lens
assembly.
• Remove the lens assembly.
• If you are about to install the MF (24º) lens kit, then insert the 7 silver spacers
onto the LED board over the seven silver stand offs that are fixed to the LED
board. Insert the lens kit by lining up the assembly with the spacers.
• If you are about to install the VN (16º) lens kit, then remove the 7 silver
spacers from the LED board. Insert the lens kit by lining up the assembly
with the stand offs.
• Replace the screws removed in the first step. Tighten until only slightly snug.
Do not over tighten.
Instructions for changing VN or MF lens kit with individual lenses and
plates:
•
!!Position the unit so the front is facing you with the filter pin on the top (12
o'clock position)
• Use a #2 phillips screwdriver to remove the seven screws from the lens face
plate. This plate is the “upper” lens plate.
• Remove the upper lens plate.
• Remove the 24 or 12 lenses (200W or 100W units)
• Remove the lower lens plate. Note that there is one unique lower plate for the
VN (16 deg) lenses and a different plate for the MF (24 deg) lenses and that the
plates are labeled. The one upper plate is used for both lens types.
• If you are about to install the MF lenses (they do not have holes in the center of
them) then first insert the 7 silver spacers onto the LED board over the seven
silver hardware pieces that are fixed to the LED board.