Manualshelf

Installation Guide

ManualsBrandsWyndham Collection ManualsBathSara 5.59 ft. Center Drain Soaking Tub in White with Floor Mounted Faucet in Chrome
123
figure 7
figure 10
PREPARATION
1. Clean, level, and prepare the floor for
installation.
2. Place the unit in the exact installed position
on the floor and trace the outline of the bath
with a pencil or any erasable marking
(figure 7).
3. Determine the location of the drain pipe,
on the floor by taking measurements of the
drain and waste location underneath the unit
(figure 8).
Note: Drain and waste locations will vary
by model.
4. Using a blanket, cardboard, or other clean
protective surface, turn the unit on its side
so that the unit is properly supported during
drain installation.
5. Clean the drain hole area in preparation of
setting the drain. The area should be dry and
free of any debris.
INSTALL DRAIN HARDWARE
6. Apply a bead of clear silicone or plumbers
putty around the Drain Body and pass it
through the drain hole (figure 9).
7.
Apply plumbers putty to the Washer and slide
it over the bottom of the Drain Body (figure 9).
8. Slide the paper washer over the drain body.
9. Attach the Drain Body Nut on the Drain
Body and tighten until the Nut and Washer
ha
ve created a seal with the bottom of the
bathtub. DO NOT OVERTIGHTEN (figure 10).
figure 9
figure 8
FREESTANDING INSTALLATION
Note: Drain, waste locations, and trim options
vary by model.
PREPARATION
1. Clean, level, and prepare the floor for
installation.
2. Place the unit in the exact installed position
on the floor and trace the outline of the bath
with a pencil or any erasable marking
(figure 7).
3. Determine the location of the drain pipe,
on the floor by taking measurements of the
drain and waste location underneath the unit
(figure 8).
4. Using a blanket, cardboard, or other clean
protective surface, turn the unit on its side
so that the unit is properly supported during
drain installation.
5. Clean the drain hole area in preparation of
setting the drain. The area should be dry and
free of any debris.
INSTALL DRAIN HARDWARE
6. Apply a bead of clear silicone or plumbers
putty around the Drain Body and pass it
through the drain hole (figure 9).
7.
Apply plumbers putty to the Washer and slide
it over the bottom of the Drain Body (figure 9).
8. Slide the paper washer over the drain body.
9. Attach the Drain Body Nut on the Drain
Body and tighten until the Nut and Washer
ha
ve created a seal with the bottom of the
bathtub. DO NOT OVERTIGHTEN (figure 10).
Note: If you purchased a brushed nickel trim
kit, it must be installed before installing
the bathtub (brushed nickel trim not
available on all models).
Drain Body
Washer

Summary of content (3 pages)