Installation Guide

Alcove Tub Installation Instructions

Installation Notes

Professional installation by a licensed plumber required. Adhere to all local building and plumbing codes.

Measure the actual tub prior to any construction or installation to ensure accuracy for rough-in.

Be sure that the oor is structurally sound and able to support the full weight of a tub with water and an

occupant. Suboor must be correctly leveled.

Support the bottom of the tub only by the feet or base of the tub. Do not use t

he rim as a supporting

area. Ensure that the tub is perfectly levelled for proper draining. The base area should be set in 1” to 2”

of mortar cement.

Access should be given to all plumbing connections.

Verify that the bottom of the apron is at the same height as the oor covering.

100% Silicone sealant is recommended.

Prior to commencing installation

Remove packaging carefully without damaging and store until installation is completed.

Inspect all areas of the tub prior to installation – the two year limited warranty does not cover any

visible defects if the tub has been installed.

Contact your retailer within one calendar week after receipt if any defect is found.

Post-Installation

To clean without scratching use a moist soft cloth and a mild liquid detergent. Do not use abrasive

cleaners, scraping tools, or any item that could damage or dull the acrylic surface.

WYNDHAM

COLLECTI O N

PAGE 1
WYNDHAM COLLECTION Alcove Tub Installation Instructions Installation Notes Professional installation by a licensed plumber required. Adhere to all local building and plumbing codes. Measure the actual tub prior to any construction or installation to ensure accuracy for rough-in. Be sure that the floor is structurally sound and able to support the full weight of a tub with water and an occupant. Subfloor must be correctly leveled. Support the bottom of the tub only by the feet or base of the tub.
PAGE 2
ALCOVE TUB INSTALLATION Note: If you purchased a brushed nickel trim kit, it must be installed before installing the bathtub (brushed nickel trim not available on all models). Warning: Due to rough handling during shipping or on the job site, do not install this product until a thorough inspection and water test has been completed. Check bathtub for correct model and size. Carefully inspect the tub for any damage (i.e., chips, scratches, cracks).
PAGE 3
Drain, waste locations and trim options vary by model. 4. Apply mortar to the floor surface. (figure 4) 5. Lift the tub into position. Make sure to align the drain with the pipe. (figure 5) 6. Level all sides of the bathtub. Apply 100% silicone sealant around the bath along the finished walls and deck .