Installation Guide

Note: Drain, waste locations, and trim
options vary by model.
PREPARATION
1. Clean, level, and prepare the floor for installation.
2. Place the unit in the exact installed position
on the floor and trace the outline of the bath
with a pencil or any erasable marking
(figure 1).
(figure 1)
(figure 2)
(figure 3)
3. Determine the location of the drain pipe,
on the floor by taking measurements of the
drain and waste location underneath the unit
(figure 2).
4. Using a blanket, cardboard, or other clean
protective surface, turn the unit on its side
so that the unit is properly supported during
drain installation.
5. Clean the drain hole area in preparation of
setting the drain. The area should be dry and
free of any debris.
INSTALL DRAIN HARDWARE
6. Apply a bead of clear silicone or plumbers
putty around the Drain Body and pass it
through the drain hole (figure 3).
Note: If you purchased a brushed nickel trim kit, it must be installed before installing the
bathtub (brushed nickel trim not available on all models).
FREESTANDING INSTALLATION
Drain Body
Washer
Warning: Due to the rough handling during shipping or on the job site, do not install this product
until a thorough inspection and water test has been completed.
Check bathtub for correct model and size. Carefully inspect the tub for any damage (i.e., chips,
scratches, cracks). If at any point during the pre-installation inspection and water test, you discover a
problem with the bathtub or piping system, DO NOT INSTALL the unit and contact us immediately.
All pre installed parts must be checked and retightened before installation.