Installation Guide

WC-R4100-24-VESSEL

INSTALLATION

Prior to installation please check received

items against the "Packing List".

Please report any missing items to your

retailer immediately.

Professional installation recommended.

Protect all surfaces from sharp objects,

high heat sources,direct prolonged

sunlight and chemical hazards.

PACKING LIST

Vanity/Counter/Sink

Electric drill Silicone Tape measure Drill bit ( Pencil Screwdriver)

INSTALLATION INSTRUCTIONS

Φ8

Insert the anchor into the screw hole

for reinforcement.

Diameter 8mm

Depth 40mm

Mark screw position

Draw horizontal line

PACKING LIST

REQUIRED TOOLS NOT IN BOX

Mark the position of the screw holes on the wall by measuring the space

between the centers of the mounting brackets on the back of the vanity.

Vertical position (X) is decided by the purchaser. Remember to mark low

enough to accommodate the sink on the top of the vanity counter or it

will be too high when installed. Use a spirit level to ensure the screw

holes are horizontal.

PAGE 1
Prior to installation please check received items against the "Packing List". Please report any missing items to your retailer immediately. Protect all surfaces from sharp objects, high heat sources,direct prolonged sunlight and chemical hazards. Professional installation recommended.
PAGE 2
3 Attach vanity to wall by lowerin g o n t o the mounting brackets 4 Ar de jq uu si tr etdh e m o u n t i n g a t t a c h m e n t a s Upper screw adjusts vertical position wall Lower screw adjusts depth 5 A ttach counter to cabinet with si l i c o n e s ealant applied to top of front a n d s i d e c abinet edges. Do not over-apply. A l l o w t o dry for 24 hours for proper cur i n g. 6 rL ei cc oe mn ms ee nd dperdo.