Installation Guide

WC-1414-60 Double
Installation Guide
4
5
INSTALLATION INSTRUCTIONS
Installer must cut appropriately sized hole
in back of cabinet to accommodate existing
placement of hot & cold wall valves and drains.
1
2
Install the counter. Seal around
the top of the cabinet with clear silicone
sealant.
3
(1)
(2)
(3)
6
Install the mirror: use a pencil to mark the
placement of the screw holes on the wall
,drill
the holes and insert the plastic wall anchors.
Install the screws into the wall anchors,
leaving enough of the screw exposed to hang
the mirror - approx 1/4" - 1/2".
Remove the handles from
inside the cabinet doors and drawers and
reinstall on the outside.Do not over-tighten
when reattaching.
6-8mm
Cut hole in back
of cabinet
Adjust the feet if needed.