Installation Guide

WC-2111-72

INSTALLATION

Ceramic sink / 1 Main cabinet / 1 Feet / 4

INSTALLATION INSTRUCTIONS

• Prior to installation please check received

items against the “Packaging List”.

Please report any missing items to your

retailer immediately.

• Protect all surfaces from sharp objects,

high heat sources, direct prolonged

sunlight and chemical hazards.

• Professional installation recommended.

Tape measure

Pencil

Electric Drill

Phillips Screwdriver

Adjustable Wrench

Spirit Level

Silicone sealant

INSTALLATION AND ADJUSTMENT OF HINGES (if required)

REQUIRED TOOLS NOT IN BOX

install remove adjust height adjust laterally adjust depth

Cut hole in back

of cabinet

1 Installer must cut appropriately sized hole

in back of cabinet to accomodate existing

placement of hot & cold wall valves and drains

2 Install the adjustable feet.

3 Install the sink and pop-up

drain. Seal around the top of the cabinet with

clear silicone sealant.

Mirror (s) (may not be

included)

PAGE 1
• Prior to installation please check received items against the “Packaging List”. Please report any missing items to your retailer immediately. • Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards. • Professional installation recommended.
PAGE 2
(1) (2) 6-8mm (3) 4 Remove the handles from inside the cabinet doors and drawers and reinstall on the outside. Do not over-tighten when reattaching. 5 Install the mirror: use a pencil to mark the placement of the screw holes on the wall , drill the holes and insert the plastic wall anchors. WC-2111-72 INSTALLATION 6 Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror - approx 1/4" - 1/2".