Installation Guide

WC-7778-30

INSTALLATION-GUIDE

Prior to installation please check received

items against the “Packing List”.

Please report any missing items to your

retailer immediately.

Protect all surfaces from sharp objects,

high heat sources, direct prolonged

sunlight and chemical hazards.

Professional installation recommended.

●

PACKING LIST

REQUIRED TOOLS NOT IN BOX

INSTALLATION AND ADJUSTMENT OF HINGES (if required)

(Not all components may be included, depending on your purchase)

Sink / 1 Main cabinet / 1 24” Mirror / 1

Screws for cabinet / 2

Cover / 2

ape Measure

Pencil

Electric Drill

Phillips Screwdriver

Adjustable Wrench

Spirit Level

Silicone Sealant

remove adjust height adjust laterally adjust depth

install

PAGE 1
● ● ● Prior to installation please check received items against the “Packing List”. Please report any missing items to your retailer immediately. Protect all surfaces from sharp objects, high heat sources, direct prolonged sunlight and chemical hazards. Professional installation recommended.
PAGE 2
INSTALLATION INSTRUCTIONS 1 Drill through the hole in the backboard as shown. Mark the wall according to the holes at your preferred height and drill holes in the wall. 3 Fasten cabinet to wall by attaching screws through the holes as shown. Use a spirit level to ensure vanity is leveled. 2 Gently tap the crew anchors into the holes with a hammer. 4 Install the counter. Seal around the top of the cabinet with clear silicone sealant. Do not over apply. Allow to dry for over 24 hours for proper curing.
PAGE 3
(1) (2) 6-8mm (3) 6 Install the mirror: use a pencil to mark the placement of the screw holes on the wall, drill the holes and insert the plastic wall anchors. 7 Install the screws into the wall anchors, leaving enough of the screw exposed to hang the mirror - approx. 1/4” -1/2”.