Instruction manual

Technical Support: [e-mail] US: [phone] EU: [phone]
10
OPTIONAL DEVICE CONNECTION, INTERFACE DEVICE, BASIC & REMOTE CONTROL OPERATION
7vi. Interface Device
9. Remote Control
Handset Operation
8. Basic Operation
For connection of local line level audio sources
(such as MP3 player, multiroom audio system, laptop/
desktop, smartphone/tablet, mixer, microphone etc)
connect a 3.5mm mini jack from the audio source to the
L/R port of the AMP-001-010
To connect stereo speakers directly to the AMP-
001-010, insert evenly stripped, good quality copper
cable of adequate gauge into the SPEAKER spring
terminal connections of the AMP-001-010 with care
taken to insert wires into correct spring clips based on
audio signal polarity (+/+, -/-).
Ensure plastic insulation is undamaged and cable is
untangled, without bends or kinks that may interfere with
transmission.
Attention: Maximum output available 25w per
channel
For increased bass range, an active subwoofer can
be connected to the SUB OUT port of the AMP-001-010
For additional amplification, the AMP-001-010
can be connected to an external power amplifier or AV
Receiver (AVR) via the stereo AUDIO OUT ports.
Attention: In such cases where an AVR is
used, the SUB OUT of the AMP-001-010 should
be connected to the SUB Input of the AVR and
a subwoofer connected to the AVR. Likewise,
speakers should be connected directly to the AVR
rather than the spring terminal connectors of the
AMP-001-010.
Using the Audio Pre-Out you can connect the AMP to
a multi-room audio amplifier system or seperate power
amplifier, and expand beyond a basic stereo pair.
The AMP-001-010 can be controlled locally via the front
panel or remotely using the handset provided or an
RS232 third party control system.
Turn on the AMP-001-010 using the POWER switch
on the front panel – LED will indicate power status.
Select the AUDIO SOURCE by pressing the SELECT
button – LED will indicate selection
Toggle standby mode to power down unit when not
in use.
Toggle mute function temporarily disables audio
output
Bass Control button, enable/disable internal cross
over to route bass signals to sub pre-out or main speaker
output.
Source selection to output audio from the main
HDBaseT input, local input jack or ARC from locally
connected TV.
Attention: TV must have ARC function and be
connected to the relevant HDMI port
Increase/decrease main speaker volume. This does
not control the line level pre-out, this is a fixed output.
Adjust output level of subwoofer pre-out port.
EQ selection buttons to equalize audio signal
depending on your taste.
1
2


3
4
1 2
3 4
5 6
7
1
4
5
6
7
2
3
1
2
7v. Optional Device
Connection