Instruction manual

Technical Support: [e-mail] US: [phone] EU: [phone]
14
11v. AMP-001-010 as Display Receiver
11vi. AMP-001-010 as In-line Solution
AMP as a Receiving Device
Simple installation of the AMP between a transmission transmission device and the display, with local, direct speaker
connection.
Choice of Transmission Device
Single source transmitter or multi-source matrix - the choice is yours - the installation procedure is identical.
Single Cat5e/6 Cable up to 70m/230ft
Delivers full 1080p 36bit HD video to display, high quality digital audio to amplifier, as well as sending and receiving IR
bidirectionally all through HDBaseT.
AMP as an in-line device*
Simple and cost effective solution for distribution incorporating in-wall or in-ceiling speakers between an
EX-1UTP-IR-70 HDBaseT extender set for total distance of 140m/460ft.
Covers Longer Cable Runs
70m/230ft from Transmitter to AMP, then another 70m/230ft from the AMP to the Display Receiver.
AMP Control Maintained
Control of central source and AMP still possible from display Location, including AMP stand-by function.
*ARC not supported in this instance
AMP-001-010 AS DISPLAY RECEIVER AND AMP AS IN-LINE SOLUTION
HDMI
t5e/6
transmitting device
mx0808-pp
tx-70-pp
cat5e/6
hdmi
amp as receiving
device
18V PSU
Ceilin Ceiling g
Audio Only
Audio Only
Audio/Video
IR TX
digital transmission over longer cable runs
digital transmission over longer cable runs >>> rs232 to amp
18v psu
hdmi
hdmi
ir Rx
EX-1UTP-ir-70
(tx)
EX-1UTP-ir-70
(rx)