Instruction manual

Technical Support: [e-mail] US: [phone] EU: [phone]
18
HYBRID IR AND RS232 ADDRESSING
RS232 Addressing
Each AMP can be addressed so serial commands can be sent over HDBaseT to control specific AMPs at specific
display points.
Software Solution
Control commands are sent from PC control software or a control system via the AMP RS232, ensuring correct COM
port selection.
Choice of Control
Each AMP can be set up with individual or group addresses to enable control of a single AMP or group of AMPs.
12v. RS232 Addressing
HDBT IN HDBT IN
HDMI with ARC HDMI with ARC
HDBT out
Cat5e/6 Cat5e/6
HDMI with ARC
hdmi with arc hdmi with arc hdmi with arc
hdbt in hdbt in
hdbt out
amp set to
address 2
amp set to
address 1
amp set to
address 1
cat5e/6 cat5e/6
18V PSU
18v psu
18v psu 18v psu
Final IR Receiver has overall control of all AMPs albeit with variations
Each AMP has local IR Control
12iv. Hybrid IR for combination of Zonal and
Global IR control of multiple AMP units
HDBT IN
HDMI with ARC
U U
HDBT out
HDMI with ARC
HDBT out
Cat5e/6 Cat5e/6
Rx-70-ir-pp
hdmi (arc not supported)
hdmi with arc hdmi with arc
hdbt in
hdbt in
hdbt outhdbt out
remote controlling
master volume for all
amps
global ir. all amps
controlled together
from display at the
end of the chain
global ir. all amps
controlled together
from display at the
end of the chain
cat5e/6cat5e/6
18V PS 18V PS
18v psu 18v psu
IR RX
ir rx
IR RX
ir rx
IR RX
ir rx
IR RX
ir rx
IR RX
ir rx
IR RX
ir rx
rs232