Instruction manual

Technical Support: [e-mail] US: [phone] EU: [phone]
9
Connect an HDMI input (such as DVD, Blu-Ray,
PS3, Satellite, Cable, media server, computer etc.) to an
HDBaseT transmission source (such as a Wyrestorm TX-
1UTP-IR-70 transmitter or a MX-PP matrix solution).
Connect a good quality, well terminated Cat5e/6
cable of no more than 70m/230ft between the HDBaseT
output of the HDBaseT transmission device to the
HDBaseT Input of the AMP-001-010
Attention: 70m/230ft is the maximum
recommended transmission distance for this
classification of HDBaseT equipment and denotes
perfect transmission conditions - including straight
cable runs with no electrical interference, bends,
kinks, patch panels or wall outlets. If any of the
above are a factor in your installation, transmission
range may be affected – take care to avoid where
possible.
Connect the HDMI sink ( such as High Definition
LED/Plasma flat panel display or HD Digital projector) to
the HDMI Output of the AMP-001-010
Connect another well terminated and good quality
Cat5e/6 cable from HDBaseT output of the AMP-001-
010 to HDBaseT input of a Wyrestorm HDBaseT Receiver
device ( such as an RX-1UTP-IR-70 receiver, or another
AMP-001-010)
Attention: The AMP-001-010 can be used as both
an HDBaseT repeater to extend the transmission
as well as a Receiver, with the inclusion of up to
7 units connected along a single cable run. As
such, an RX-1UTP-IR-70 receiver is only required
to extend the final leg of the distribution a further
70m/230ft, or if HDMI output and IR/RS232 control
only is required.
As before, connect the HDMI sink ( such as High
Definition LED/Plasma flat panel display or HD Digital
projector) to the HDBaseT Output of the HDBaseT
Receiver device.
Repeat process for all AMP-001-010 units installed along
your cable run.
For two way control of connected sources and
displays from either location, connect IR TX infrared
transmitter emitters to the IR TX ports of the HDBaseT
Transmitter devices and AMP-001-010.
Insert IR RX infrared receiver emitters into IR RX
ports of the HDBaseT Receiver devices and AMP-001-
010.
If using an RS232-based control system, insert
cables into the RS232 ports of devices to enable RS232
control signal transmission ( Default set for RS232).
Connect the AMP-001-010 to a mains power
source using the 18vDC power supply included.
Attention: The AMP-001-010 is capable of
Power-over-HDBaseT passthrough distances up
to 50m/164ft when used between PoH-enabled
devices such as a MX-PP-POH matrix or POH
transmitters and receivers.
The AMPs themselves will still require mains power
for operation but are able to passthrough power
from a PoH transmission device to a PoH receiver
to negate the need for mains power at the display
end.
1
1
4
4
5
2
2
3
3
7iii. Initial Connection
7iv. IR/RS232 Control
Connection
RJ45 TERMINATION, INITIAL CONNECTION AND IR/RS232 CONTROL CONNECTION
7ii. RJ45 Termination
HDBaseT Class D Digital Audio Amplier / Receiver / Repeater
AMP-001-010
Cat5e Wiring Guide
The quality of termination for every RJ45 is essential.
Poor terminations leads to intermittent performance
and longer install times