Instruction manual

26
Technical Support: [e-mail] US: [phone] EU: [phone]
BEFORE EDID ADJUSTMENTS AND EDID PRESETS
21. EDID Presets
Copy EDID from the HDMI sink
device to the currently selected
input port
For example, when output-3 select
input-1, the EDID of output-3 will be copied to input-1.
(An HDMI output takes precedence over a UTP output. If
a copy fails, the EDID will remain the same.)
1 2 3 4
ON
✳
1 2 3 4
ON
✳
The matrix will use 3D compatible
1080p-stereo EDID when the DIP
switch is in this setting.
1080p 3D stereo
1 2 3 4
ON
✳
The matrix will use 1080p-stereo EDID
when the DIP switch is in this setting.
1080p stereo
1 2 3 4
ON
✳
The matrix will use 1080i-stereo EDID
when the DIP switch is in this setting.
This setting is useful if using an older
model TV or if the screen does not support full 1080p.
1080i stereo
1 2 3 4
ON
✳
The matrix will use 3D compatible
1080p-5.1 EDID when the DIP switch is
in this setting.
1080p 5.1
1 2 3 4
ON
✳
The matrix will use 3D compatible
1080p-7.1 EDID when the DIP switch is
in this setting.
1080p 7.1
1 2 3 4
ON
✳
Reserved
1 2 3 4
ON
✳
Reserved for future use
Normal Output
This setting instructs the matrix to
check the hotplug voltage and EDID of
the sink device prior to outputing the
HDMI signal.
1 2 3 4
ON
✳
Reserved
Reserved for future use
1 2 3 4
ON
✳
1 2 3 4
ON
✳
Force Output
This setting instructs the matrix to
continually output HDMI signals
regardless of hotplug voltage being
detected from the sink device.
20. Before EDID
Adjustments
Communication between sink, matrix and source devices
should be automatically negotiated with the EDID DIP
switch set to the default Normal Output (OFF) position.
However, should device communication or compatibility
issues be encountered during installation, please refer to
the EDID DIP settings below.
If the maximum capabilities of the display are known, for
example 1080p 3D with 2ch stereo audio, the DIP switch
setting should be adjusted manually for matching EDID to
be sent to the matrix.
If the specification of the display is not known, simply
copy the EDID from the display to matrix through the
HDMI connection by setting all switches to the EDID Copy
or Force Output (ON) positions and power cycling the
matrix for the DIP setting to become active.
NOTE EDID Switches that are marked in grey
indicate the switch can be in any position.