Instruction manual

19Technical Support: [e-mail] US: [phone] EU: [phone]
RS232 CONTROL
Click Open to connect this COM debug software to
the matrix.
Enter the command bc + “Enter”, which should give
the resultant feedback from the system: “s18\r\n” ,”s27\
r\n” ,”s36\r\n” ,”s45\r\n” ,”s54\r\n” ,”s63\r\n” ,”s72\r\n”,
”s81\r\n”
See below for an explanation on the meaning of this
feedback message
viii) Controlling the IR Devices Remotely
The matrix allows the creation of different IR paths to
remotely control the IR devices, such as sources or
displays using device remote handsets from the display or
source location.
Note:
Ensure IR receivers are securely connected to correct
ports of receiver or matrix and placed in clear view to
receive IR signals from device remote handsets.
IR emitters must be firmly connected to correct ports
of matrix and securely attached directly over device IR
sensor windows.
All IR cables should be free of bends, kinks, tangles,
knots and any interference that may restrict signal
transmission.
See Troubleshooting section should problems be
experienced.
Controlling at the Display End
Combinations of matrix IR TX ports and HDBT OUT ports
correspond to IR RX ports of HDBaseT receivers and
change with the switching configuration of matrix inputs
and outputs. By default, IR TX ports 1~8 correspond to
HDBT OUT ports 1~8 in the matrix in sequence.
For example, if current output and input combinations
in the matrix are as below, combinations of matrix IR TX
ports, HDBT OUT ports and IR RX ports in the HDBaseT
receivers will be as follows (Diagram right):
3
4
Output Port 1 2 3 4 5 6 7 8
Selection
Input Port 8 7 6 5 4 3 2 1
→ → → → → → → →
1
2
3
Output Port 1 2 3 4
Selection
Input Port 4 3 2 1
→ → → →