Instruction manual

11
Technical Support: [e-mail] US: [phone] EU: [phone]
Receive Message Window – displays messages
received from the matrix, such as input/output settings
and command selections.
You can view the current condition of all input/output
ports by pressing the
button.
Pressing
will delete the previous message received in the window.
Send Message Window – Input your serial
commands for the matrix in the Send Message Window -
such as instructions for outputs or to enter update mode
– and click the Send button to deliver the message to the
Matrix. The control command uses ASCII.
RS232 Control
To update the system firmware, enter the following code
into the Send Message Window, ensuring to include one
space between each section of the code.
Code: ICP BE 7C 5F
Press Enter, then Send Message
to put the matrix into firmware update mode.
Press the Connect button and run the firmware.
When the firmware has finished updating, press the same
button again to Connect and powercyle the matrix (turn
off and on).
Updates are now active and the firmware is now updated.
Attention To see the firmware version currently
used in the system – power off and repower while
the matrix is connected to COM CTL. The firmware
version and creation date will be displayed together
with the normal output state of the matrix.
Com Connect State – Shows if the matrix is
connected or disconnected to the Com Port and
communication is enabled. Selection between ports is
available by pressing the Com Port Select button.
When connected, the only option will be to Disconnect
and vice versa. Press to connect/disconnect the
matrix from the software control.
1
1
2
2
3
3
4
5
5
5
6
7 8
9
ADVANCED OPERATION