User's Manual

FCC Statement

This equipment has been tested and found to comply with the limits for either Class

A or Class B digital devices (refer to “Terminal Requirements Compliance”)

pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution

Changes or modifications not covered in this manual

must be approved in writing by the manufacturer’s

Regulatory Engineering department. Changes or

modifications made without written approval may void

the user’s authority to operate the equipment.

Terminal Requirements Compliance

The T1010 and Evo T20 terminals meet Class B requirements.

Canadian DOC Notices

Class A

This digital apparatus does not exceed the Class A limits for radio noise emissions

from digital apparatus set out in the Radio Interference Regulations of the

Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les

limites applicables aux appareils numériques de la classe A prescrites dans le

Réglement sur le brouillage radioélectrique édicté par le Ministère des

Communications du Canada.