Manual
6. Important Seal Information
7. Button Pad Control
Play / Pause Button
Next / Fast -
Forward Button
Previous / Rewind
Button
Volume up
Volume down
The most important feature of the iSH2 Headset Case is the removable Seal that forms a
waterproof barrier between the base and lid of the case. It is extremely important that
special attention is paid to ensure the Seal is completely seated in the groove of the lid.
If the Seal is loose, out of alignment, twisted or pinched in any way it will compromise
the integrity of the case and should not be used. Any debris such as hair or sand on the
Seal will keep it from forming a watertight barrier and should be cleaned off before use.
If you have any concerns please contact H2O Audio Customer Support.
Caution: If the Seal comes out of alignment, carefully place it in the groove, ensuring all 4
corners are correctly installed. It should be difficult to fit in the groove. Compress the lid to
the base and then re-open it to make sure the seal is fitted correctly into the groove. It
should appear straight and uniform along its’ edge, and not fall out easily.
SealSeal
water
shuffle
shuffle
5. Installing the shuffle into the Shuffle Case
Open Case
Close Case Ensure the case is
closed and locked.
Plug audio jack into the shuffle player, place shuffle into case and ensure the
control pad and the Button Pad Control are aligned. Close case.
a
b
c
d
e
f
3. Introduction
The H2O Audio iSH2 Headset allows for an all-in-one waterproof solution (up to 10ft. /
3m) for the iPod shuffle (2
nd
Gen). Allowing you to listen to digital audio during active
watersports, like swimming. The Shuffle Case allows for functional control of the player
while in the water with the Button Pad Control. NOTE: The Case has no access to the
Shuffle Switch or On / Off Switch on the iPod shuffle.
The headset includes Waterproof Speakers, made for complete submersion up to
10ft.(3m) and designed with Removable Earbuds which can be used with the included
Goggle Clips to stay secure when wearing swim goggles.
Note: The iPod shuffle (2
nd
Gen) is NOT waterproof without the iSH2 Headset and is NOT
covered under the product warranty. Any attempt to use the iSH2 Headset with an audio
player other then the Apple iPod shuffle (2
nd
Gen) will void the warranty.
CAUTION: The earbuds insert directly into the ear, and are not to be used during SCUBA diving.
Prolonged exposure to pressures at depths beyond 10ft.(3m) may result in permanent hearing loss.
Discontinue use at the first sign of pain or discomfort.
Before using the iSH2 Headset it is recommended you perform an Audio Test.
1. Install the shuffle player into the Shuffle Case and verify that audio is audible through
both speakers. If speakers are working remove the shuffle player and perform the leak
test.
2. If your earbuds are operating at very low audio levels, it is possible that a vacuum has
formed in the speaker chamber due to exposure to low pressure, such as in air travel.
3. Playing the headset at 90% volume for an hour typically solves this problem. If not,
please contact H2O Audio Customer Support.
4. Audio / Leak Test
Before using the iSH2 Headset it is highly recommended to perform a Leak Test.
1. Open the case (Section 5), and verify the seal area is clean and free of debris or damage.
Place a piece of tissue paper completely in the case before closing. (Ensure tissue does not
interfear with the Seal of the Shuffle Case)
2. Immerse the headset, (without the iPod shuffle 2
nd
Gen) in water and soak for 30 min.
3. Manipulate the Button Control Pad during submersion.
4. Remove from the water, dry the exterior.
5. Open the housing and ensure there is no water in the case.
DO NOT INSTALL THE iPod shuffle 2
nd
Gen INSIDE THE CASE FOR THE LEAK TEST
In the event of an unscuessful Leak Test contact H2O Audio Customer Support immediately.
2. iSH2 Features
Adjustable
Removable Earbuds
Button Pad Control
Aquatic Silencer Earplugs
Goggle Clips
Waterproof Speakers
Adjustable Ear-clips
Removable Neckwrap
shuffle Case
Neckwarp Configuration
Goggle Clip Configuration
Before using this system, please be sure to read, understand, and follow the instruction of this manual.
H2O Audio cases are designed for specific Apple iPod models, which vary by
generation and storage size. You must ensure the correct housing or case is
purchased for your specific iPod model.
Printed Instructions
Waterproof Headset for the shuffle (2
nd
Gen)
iSH2
h2oaudio.com
iSH2-70 20080312