User Guide

Gigabit PCI/PCIe Network Adapter
Page | 4
1.2 Features
 Fully complies with IEEE 802.3, 802.3u, 802.3ab standards
 Support IEEE 802.1p Layer 2 Priority Encoding; IEEE 802.1q VLAN Tagging
 Compliant with 32-bit PCI or PCIe Standard
 Support 10/100/1000Mbps NWAY Auto Negotiation
 Support Jumbo Frame (XM-NA3500)
 Support ACPI, PCI power management
 Wake-on-LAN and remote wake-up support
 Crossover Detection & Auto-Correction
 Support Standard and Low-Profile Chassis
 LED indicator for monitoring Link/Act
1.3 LED Status
The Link/Act LED of Adapter indicates 10/100/1000Mbps status. They will light when
connection is built, and glitter when the Adapter is transmits and receive data.
Chapter 2 Installation Guide
2.1 Hardware Installation
To Install the Adapter, please follow these steps listed below:
1. Turn off your computer and unplug the power cord and all cables
2. Remove your computer’s case cover
3. Locate an available PCI/PCIe slot
4. Remove the screw that secures the slot bracket (the small piece of metal that covers the
opening for PCI/PCIe card on the back panel of your computer), then remove the slot
bracket
5. Carefully insert the Adapter into the PCI/PCIe slot. Please avoid touching the gold
connector of the Adapter
6. Secure the Adapter to the case by using the screw you removed from the slot bracket
7. Reinstall your computer’s case cover
8. Plug in the power cord and all other cables, and then turn on your computer