Installation and Operating Instructions

ManualsBrandsX-POWER ManualsElectronicsWireless remote control module

Wireless Remote Control Instructions

X-power wireless remote works lets you operate your winch from up to 75 ft.

without cables or switches. Just press the remote transmitter and you're ready

to operate your winch Start, stop, in or out.

◆ Remote range up to 75 ft.

◆ Transmitter equipped with long life.

◆ Battery and power saver circuit.

◆ Transmitter & receiver.

◆ Visual indicator light shows remote operation.

◆ Additional transmitters available to operate receiver.

◆ Installs in minutes.

◆ Transmitter replacement battery readily available.

WARNING: The Wireless Remote is designed for use on front mount self-

recovery winches only. The remote is not designed for and should not be used

on winches or hoists in industrial applications (commercial car haulers/carriers,

wreckers, cranes, etc.) or for any other remote controlled applications.

Part List:

1. one transmitter.

2. one receiver with connector.

Installation and operating instructions:

female connector

solenoid control box

Transmitter

Receiver

We suggest operate your winch as follows:

1. Disengage the clutch of your winch.

2. Pull out the winch wire rope about 1.5 meters.

3. Reengage the clutch of your winch.

4. Insert the plug of the receiver into the winches control box female

connector

5. Put your receiver at a certain place.

6. Pull out the antenna of transmitter, and move down the cover of your

transmitter, bare out the control button.

Summary of content (3 pages)

PAGE 1
solenoid control box Wireless Remote Control Instructions female connector X-power wireless remote works lets you operate your winch from up to 75 ft. without cables or switches. Just press the remote transmitter and you're ready to operate your winch Start, stop, in or out. ◆ Remote range up to 75 ft. ◆ Transmitter equipped with long life. ◆ Battery and power saver circuit. ◆ Transmitter & receiver. ◆ Visual indicator light shows remote operation. ◆ Additional transmitters available to operate receiver.
PAGE 2
Trouble Solving: Battery replacement for transmitter: Battery parameters: 12V23A Battery quantity：2 battery capacity: 50mAh battery type：MN21 Battery sizes as below： SYMPTOM Motor turns, but Winch does not work, Motor does not turn, but you can hear “Click” sound in the receiver Motor runs in one direction only No actions POSSIBLE CAUSE SUGGESTED ACTION Defective winch. Check the winch Operating instructions. Receiver Loose connections to the winch. Reinsert the wire. Defective winch.
PAGE 3
Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.