User's Manual

The charging of the enclosed Radio on the other maker’s charger will
cause damage on the battery and also, will cause a tro
uble on the
Radio.
2) Please charge the battery before using the radio for best performance and safety.
3) When you charge the battery that is installed in the Radio, please turn off the radio first to charge
the battery.
The continuous rapid discharge (for example, when making a short circuit
on the ‘+’ terminal of battery by a metal substance) may make a fatal defect
and the battery can be exploded. Also, it can cause a fire.
4) Using the correct battery will improve the efficiency and safety.
7.2 The Time of Charging
Low battery voltage maybe cause to reduce communication coverage and also make the
performance worse. Please charge the battery in case of following:
1) After 10-15 hours after use, recharge when you think the performance of the radio has
degradation.
2) The red lamp on RX/TX LED blinks. (every 0.5 second), during transmission or reception.
3) When the battery icon is blinks
4) While the radio is in use, “beep” sounds.
7.3 How to Charge
1) Plug the adapter of the XC-100/XC-200 charger in general power AC220V power outlet.
2) When charging the battery that is equipped with radio, please turn off the power of
the Radio and plug the Radio in the charger.
3) XC-100 is a single slot charger and XC-200 is dual slot charger.
4) Even if charging is completed ( green lamp lights), please charge more for about 30
minutes for a full charge.
11