Instruction manual

OVERVIEW AND SETUP
1-3
Features
Electronic Filter Selection - eliminates the problems that mechanical
filter wheels create.
Large Liquid Crystal Display and Electroluminescent Backlighting -
allows optimum legibility.
Larger and Fewer Keys - which have been functionally placed for ease
of operation and to cut down operator confusion.
Sequence - allows for a setup of a measurement routine to meet the job
requirements. Once a sequence structure has been setup, the 361T will
automatically select the function for each step, then advance to the next
step, step by step. (A maximum of 36 steps) x10 provides an extra digit
of display when extreme resolution is required.
RS232 Interface & RCI - (Remote Control Interface) provides a two-
way interface for use with computerized quality control systems and
electronic printers.
Lamp Timer - if enabled, automatically turns OFF Reading lamp after 2
hours of instrument non-use. This will extend the life expectancy of the
read lamp.
Ortho and UV - responses allow measurements on a broad range of
films.
Density - provides density and density difference measurements.
+Dot - allows positive dot measurements with zeroing to a Base Dot.
+Dot can be calculated for a Base equal to 0% Dot or can be adjusted to
a value equal to a known Dot size (ex. 3%).
Dot allows negative dot measurements with zeroing to a Base Dot.
Dot can be calculated for a Base equal to 100% Dot or can be adjusted
to a value equal to a known Dot size (ex. 97%).
Unpack and Inspect
After removing the instrument from the shipping carton, inspect it for
damage. If any damage has occurred during shipping, immediately
contact the transportation company. Do not proceed with installation
until the carrier’s agent has inspected the damage.
Your instrument was packaged in a specially designed carton to assure
against damage. If shipment is necessary, the instrument should be
packaged in the original carton. If the original carton is not available,
contact X-Rite to have a replacement carton shipped to you.