Instruction manual

361T
DENSITOMETER
5-1
5. Mode Selection
General Information
The Mode function controls four factors: x10 On/Off, I/O Port set-up,
Sequence setup, and Read Lamp On/Off. Modes come preset from the
factory as follows:
1. x10 [OFF] 3. SEQUENCE
SQ [OFF]
2. I/O PORT COL [ADJ]
RCI [ON] SQ [ORDER]
RPT [OFF] SIZE [36]
P5 [OFF] SKIP [00] (Skip Step 0)
BAUD [1200] FUNCTION STEP [all set
HRD [OFF] to DEN]
DPT [ON]
COMP [ON] 4. READ LAMP [ON]
CR [LF]
To change any of the above settings refer to the setup procedures in
Chapter 5 which follow: x10 On/Off, I/O Port Setting, Sequence Structure,
and Read Lamp.
NOTE: If no Modes can be accessed in Mode Selection, refer to
"311 Emulation" in Chapter 2 to turn Off 311 Emulation.
x10 ON/OFF
When activated, the x10 function allows an extra digit to be displayed
when extreme resolution is required.
1. Depress [
FUNCTION] and [COLOR] keys at the same time until "N
Dcal Y" is displayed.
2. Depress [
FUNCTION] for NO.
3. Depress [
FUNCTION] for NO.
4. Depress [
ZERO] for YES.
5. Depress [
ZERO] to turn x10 ON or OFF.
6. Press [
FUNCTION] four (4) times to return to normal operation.