Instruction manual

CHAPTER SIX

6-6

T [BAUD] is used to change the baud rate of the 361T. The unit must

receive the following as the address and the action codes portion of

the command string:

XXT

—— Action Code

———— 03 = 300 baud

06 = 600 baud

0C = 1200 baud

18 = 2400 baud

30 = 4800 baud

60 = 9600 baud

After the 361T receives the first delimiter (#4 in the command

string), it automatically performs a "g LF" (#5 and #6 in command

string). The unit should not receive an additional "g<LF>".

A command string with a "T" as the action code with no address

preceding it, sent to the 361T at the correct baud rate will force the

361T to transmit the proper hexadecimal code for its baud rate.

U [UPDATE] command must be received by the 361T after any write

commands to internal or external RAM Memory and after any "Y"

action codes. This command forces the unit to update the data

written to RAM or process a "Y" action code and forces a position

within a function as determined by an address preceding the "U"

command. The 361T must receive the following as the address and

action code portion of the command string.

U———— Action Code

————— 1 = forces display to data level

0 = forces display to beginning of

function

V [VERSION] transmits the software date code (that is displayed on

the character displayed during power-up), and a <CR> or

<CR><LF> to the serial port.

X-RITE 361 VER. XXXX (XXXX = Date Code)