Operator`s manual

CHAPTER FOUR
4-14
• CTS – CTS/RTS hardware hand shaking used. This
method ensures the instrument is working before sending
a hand shake.
• BUSY – BUSY hand shaking used.
To set the hand shake method:
1. Use the Tab keys $@ to highlight Hand Shake.
2. Press the Enter key # to access the editor.
3. Use the Tab keys $@ to highlight the desired hand
shake method.
4. Press Enter key # to save the setting and return to
the Serial Port menu.
Auto Xmit
To enable or disable automatic transmission:
1. Use the Tab keys $@ to highlight Auto XMT.
2. Press the Enter key # to access the editor.
3. Use the Tab keys $@ to highlight the desired mode,
On-with Status, On-No Status,
Spreadsheet,
or Off.
4. Press Enter key # to save the setting and return to
the Serial Port menu.
Serial Port
Baud Rate :9600
Hand Shake :Off
Auto XMT :Off
Separator :Comma
↓
<Edit Options>
Serial Port
Baud Rate :9600
Hand Shake :Off
Auto XMT :Off
Separator :Comma
↓
<Edit Options>
Off, XON, CTS, BUSY
On-with Status
On-no Status
Spreadsheet
Off