Operator`s manual

SETTING INSTRUMENT CONFIGURATION
4-17
3. To set the power down time (in seconds), use the Tab
keys $@ to choose the desired digit (arrows above and
below designated selection). Press the Enter key # to
access the editor.
NOTE: Highlighting Clear and pressing the Enter key # is a quick
method to zero the value.
4. Use the Tab keys $@ to highlight the desired number
and press the Enter key # to exit the editor.
5. When editing is completed, use the Tab keys $@ to
highlight Save & Exit and press Enter key #.
Speed Read Option
The Speed Read configuration allows you to set the time
duration the reading motor remains on after a measurement.
The time setting can range from 0 to 9 seconds (three being
the default value). This feature is useful when quick
measurement of consecutive patches is desired.
To set the dwell time:
1. Use the Tab keys $@ to highlight Speed Read.
2. Press the Enter # key to access the
Dwell Time menu.
3. To set the time (in seconds), make sure the digit is
highlighted (arrows above and below designated
selection) and press the Enter key # to access the editor.
NOTE: Highlighting Clear and pressing the Enter key # is a quick
method to zero the value.
4. Use the Tab keys $@ to highlight the desired number
and press the Enter key # to exit the editor.
5. Use the Tab keys $@ to highlight Save & Exit and
press Enter key #.
CONFIGURATION
↑
Serial Port :9600
Power Down :120 sec
Speed Read :3 sec
Display :Right
↓