Operator`s manual

INSTRUMENT FUNCTIONS

5-5

NOTE: Reference will not appear in the measurement list unless

DEN–REF01 is selected as the active density mode. Refer to Density

Measurement Mode earlier in this section.

Reference Seq

Ref 01

Ref 02

Ref 03

Ref 04

V 1.36

C 1.23

M 1.50

Y 1.65

2. Press the Tab Up key $ to highlight the reference

measurement method (Seq or Match).

• The Sequence (Seq) method automatically increments the

reference position as you measure. For example, when the

highlight is on Ref 01, and a measurement is taken, the

data is set for reference one and the highlight advances to

Ref 02.

NOTE: When position 16 is reached, you must manually move the

highlight using the Tab keys $@ if you want to restart the

measurement sequence before exiting.

• The Match method is used to update an existing

reference. The measurement automatically replaces data

in the location that has the closest match to the

measurement.

3. Press the Enter key # to alternate between Seq and

Match.

4. Center the target window over the first reference (or

replacement reference if a match), and lower the

instrument to take a reading.

5. Continue with additional reference measurements.

To manually edit reference values:

1. If not selected, press the Tab Up key $ or Tab Down

key @ to highlight Reference. Press the Enter key #

to access the reference menu.

NOTE: Reference will not appear in the measurement list unless

DEN–REF1 is selected as the active density mode. Refer to Density

Measurement Mode earlier in this section.

2. Use the Tab keys $@ to move the highlight to the

desired reference location.

Reference

measurement method