X-SENSE Doorbell Kit User Manual Fit for: 1 Transmitter with 1 Plug-in Receivers 1 Transmitter with 2 Plug-in Receivers
Thank you for purchasing this product. To ensure proper use and trouble-free operation, please read this manual carefully and store it in a safe place for future reference. IMPORTANT SAFETY INSTRUCTIONS AND GUIDELINES To ensure sufficient signal range, do not install the transmitter close to metals. The signal range varies depending on obstacles in the line of sight between receiver and transmitter. Never attempt to repair any parts of the device.
INSTALLATION Transmitter Battery Unsealing Before first use, gently pry open the rear cover of the transmitter and peel off the seal on the button cell. Ensure correct polarity of the battery and close the battery compartment cover. Transmitter Installation To ensure sufficient wireless range, do not install the transmitter close to metals. Adhesive Tape (recommended for water resistance) 1. Clean all surfaces to be used for adhesion with rubbing alcohol. 2.
The indicator on the transmitter does not light up. The receiver does not respond to the transmitter. The seal on the button cell has not been peeled off. Peel off the seal. The battery power is low. Replace with the new battery. The battery is not properly installed. Take out the battery and install again. Make sure the contacts are good. Pairing failed. Pair the transmitter and receiver again. The transmitter is placed too far from the receiver or there are obstacles between them.
Disposal This product must not be disposed of as household waste. Dispose of the device at an authorized collection point for the recycling of electrical appliances. Email: support@x-sense.