Safety Instructions

Product Overview
1. LED Indicator
2. Test/Silence Button
3. Rear Cover
4. Battery
Operating Instructions
Battery Installation
Open the rear cover by inserting the included key into the notch at the bottom of the remote
controller’sbackside and pry open. Peel off the insulating film on the button cell.Ensure the correct
polarity of the batteryand close the cover.
Pair Remote Control with the X-Sense Wireless Interlinked Alarm
1. Choose one alarm out of the interconnected alarms. Press its test/silence button 4 times. This
alarm will beep once and the red LED will keep flashing slowly, indicating that it enter pairing
mode.
2. Press the test/silence button on the remote controller2 times to enter pairing mode; its LED
indicator will flash continuously.
3. Once pairing is successful, the LED indicator on the remote controller will light up and then