Safety Data Sheets (SDS)

Reviewed on: 25/Sept/2019
Revision N°: 1
HDS: 0042 (under NTC 4435 & SGA)
Page 4 of 9
PVA ADHESIVES
Keep vessels tightly closed, in a dry place and at temperature between +41°F (+5ºC) and +86°C (+30°C).
Store in a cool and dry area.
Maximum Time: 12 months.
Keep out of reach of children and animals.
Avoid sources of heat, radiation, static electricity and contact with food. For additional information see section 10.
Specific end use(s):
Except for the instructions already specified it is not necessary to provide any special recommendation regarding
the uses of this product.
Waste handling:
Wastes must be stored in an appropriate recovery container and disposed by the competent authorities.
SECTION 8
CONTROLS OF EXPOSITION AND PERSONAL PROTECTION
Control parameters:
ACGIH TLV
HAZARDOUS SUBSTANCES
TWA
STEL
N-butyl acetate
50 ppm
150 ppm
Vinyl Acetate
10 ppm
15 ppm
2-Bromo-2-Nitropropane-1,3-Diol
No available
No available
Mix: 5-Chloro-2-methyl-4-Isothiazolin-3-
one y 2-metyl-4-isothiazolin-3-one
No available
No available
TWA and STEL data updated on June 2018
For more information on the substances go to: https://www.osha.gov/dts/chemicalsampling/toc/chmcas.html
Seek the local of State regulations on the exposure limits.
Engineering controls:
Provide exhaust ventilation or other engineering controls to maintain vapor concentration in the air below threshold
limit value.
Ensure that there is safety shower and eye wash in the working area.
Provide the appropriate safety equipment for the staff handling the product, such as:
Eye protection: Wear eye protection glasses against splashes.
Hand protection: Wear neoprene or nitrile gloves, with non-spilled and long-sleeve clothing.
Body protection: Wear protection clothing when handling.
Respiratory protection: The use of protection equipment will be necessary if a mist forms or if the
occupational exposure limits are exceeded (Wear half-face mask approved according to the product type
(NIOSH) when handling, especially in poorly ventilated spaces).
SECTION 9
PHYSICAL AND CHEMICAL PROPERTIES