User's Manual

USER MANUAL
SAFETY AND WARRANTY
10
2.2 Safety label on the device
You find the following safety label on the ML-N4000 top side:
Burning hazard due to hot surfaces
Continuous operation can strongly heat up the ML-N4000.
As a result, it can burn the skin on the hands when
touching it.
 Wear temperature-resistant ESD gloves when in
contact with the ML-N4000.
2.3 General safety instructions
DANGER
Electric shock caused by damage to components
Any damage to the ML-N4000, power source or connection
cable may cause an electric shock.
 Switch on the ML-N4000 only if all components
appear undamaged.
 Only commission the ML-N4000 after a proper
installation or repair.
 Check the connecting cable regularly for defects to
prevent damage to the power source.
 Always install the ML-N4000 in de-energised status.
WARNING
Defects influencing the environment
The incorrect ML-N4000 configuration can lead to the
temporary or permanent functional failure of connected
vehicles.
Connected vehicles being operated on public roads bear
an increased risk of injury and damage.
 If available, use configuration templates provided by
the vehicle manufacturer.
 Use preferably the passive recording modes of the
interfaces.
CAUTION
Device damage due to short circuit
Bent connector pins pose a short circuit risk. This can lead
to abnormal behaviour or destruction of the ML-N4000.
Likewise, devices connected to the measurement setup
may be also compromised.
 Make sure that connector pins are not bent.
 Check the ML-N4000 regularly for any deficiencies.