User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety and warranty
- 3 Product description
- 4 Commissioning
- 5 XorayaSuite
- 6 Maintenance
- 7 Storage, transport and disposal
- 8 Appendix
USER MANUAL
XORAYASUITE
116
5.7.2 HDD mode
In this mode, the ML-N4000 saves to one of the following media:
▪ Internal storage medium (default)
▪ USB flash drive if Record on USB stick in the Hard Disk category is
checked and the conditions described there are met (➔ Hard Disk)
▪ Additional device XORAYA ESU (automatically if detected by the ML-
N4000)
Start data recording:
Connect the ML-N4000 to the measurement environment.
(➔ Connecting the ML-N4000 to the measuring environment)
Optionally:
Connect a USB flash drive to the USB host interface (K).
(➔ Connections and controls)
Optionally:
Connect a XORAYA ESU to the corresponding interface (I).
Turn on the ML-N4000.
Start the HDD recording by pressing the trigger button (B) on the ML-
N4000.
Data received via the interfaces are recorded.
Stop data recording:
Press the trigger button (B) for at least 3 seconds.
Configuration of trigger button
The behaviour of the trigger button can be configured via
the button interface. (➔ Button)
HDD mode in the XORAYASuite
You can also start and stop the HDD mode from the
Configuration, Online-Logging, Hdd-Download and
Firmware-Update tools.
Data recorded on the storage medium is stored as sessions. Sessions always
contain complete messages and are limited to a maximum size which
defaults to 1000 MB.