User's Manual

USER MANUAL
SAFETY AND WARRANTY
14
X2E GmbH shall assume no liability for damages arising from faulty
recorded data, as well as damage due to incorrect configuration, data entry
and data transfer.
After configuring, we recommend to verify the proper operation and
plausibility of each sensor using some manual measurement over the entire
measuring range.
X2E GmbH shall assume no further liability. This limitation of liability also
applies to the personal liability of employees, representatives and organs of
X2E GmbH.
2.7 FCC notice
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
▪ Reorient or relocate the receiving antenna.
▪ Increase the separation between the equipment and receiver.
▪ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
▪ Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved
by may void the FCC authorization to operate this equipment.