User's Manual

USER MANUAL
XORAYASUITE
162
5.14.7 Create trigger conditions
You use this control element to configure general signal triggers or triggers
of the VIDEO, DiagCCP, DiagXCP and Event interfaces.
The following trigger types are available:
▪ Value compare Raise trigger if a single condition or combined
conditions are met
▪ Signal list Raise trigger if the ML-N4000 detects one of these
signals on the data buses
Value compare:
1
Apply trigger
7
Parenthesise selection
2
Cancel trigger configuration
8
Clear selection
3
Add condition
9
Signal
4
Remove condition
10
Relation
5
Move selection to right
11
Relation type
6
Move selection to left
12
Operator
The following Relation types (11) are available:
Signal value
Number of occurrences of this signal
Time since the last occurrence of this signal (in ms)