User's Manual

USER MANUAL
MAINTENANCE
167
6 Maintenance
6.1 Safety measures
DANGER
Electric shock caused by damage to components
Any damage to the ML-N4000, power source or power
supply cable may cause an electric shock.
 Switch on the ML-N4000 only if all components
appear undamaged.
 Only commission the ML-N4000 after a proper
installation or repair.
 Check the power cable regularly for defects to
prevent damage to the power source.
 Always install the ML-N4000 in de-energised status.
CAUTION
Device damage due to short circuit
Bent connector pins pose a short circuit risk. This can lead
to abnormal behaviour or destruction of the ML-N4000.
Likewise, devices connected to the measurement setup
may be also compromised.
 Make sure that connector pins are not bent.
 Check the ML-N4000 regularly for any deficiencies.
CAUTION
Safety defects due to incorrect accessories and spare
parts
Accessories and spare parts that have not been
recommended by X2E GmbH negatively affect the safety,
functionality and precision of the ML-N4000.
X2E GmbH shall assume no responsibility whatsoever or
honour any warranty for damages arising from non-
recommended accessories and spare parts or incorrect
use.
 Use only accessories recommended by X2E GmbH
and original spare parts.