User's Manual

USER MANUAL
COMMISSIONING
30
The ML-N4000 is equipped with an intelligent energy management system
that lowers power consumption to about 1 mA (at 12 V supply voltage) in
sleep mode.
The device goes into sleep mode via the following actions or under the
following conditions:
▪ Pressing and holding the power button (A) for at least 2 seconds.
Current recording stops automatically.
▪ If no data reach the log interfaces and no connection to the
XORAYASuite is established for 10 minutes, the ML-N4000 shuts down
automatically. This behaviour is configured using the main setting
Automatically Switch Off. (➔ Main Settings)
Users can wake up the ML-N4000 from sleep mode as follows:
▪ Pressing the power button (A)
▪ Switching the power supply off and on
▪ Signal change from 0 V to +12 V at the trigger or wake input (L)
▪ Pressing the trigger/wake button (B)
▪ Activity on a wakeable log interface
4.6 Connecting the ML-N4000 to the PC
This section describes how to connect the ML-N4000 to the PC. To do so,
you will need a standard network cable.
Proceed as follows to connect:
 Connect the network cable to a switch.
or
 Connect the network cable directly to your PC.
 Connect the network cable to one of the LAN host interfaces (H) or the
10 Gbit Ethernet interface (G). (➔ Connections and controls)
 The ML-N4000 is fully connected.