User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety and warranty
- 3 Product description
- 4 Commissioning
- 5 XorayaSuite
- 6 Maintenance
- 7 Storage, transport and disposal
- 8 Appendix
USER MANUAL
XORAYASUITE
63
Configure trigger responses:
Select the check box Send as response following CAN message.
Specify the ID of the CAN message that is sent as response to a trigger.
Select the check boxes Extended Frame, Can FD and Bit Rate Switch as
desired.
Specify the Number of bytes for the response (3).
Specify the Byte values of the response (4).
Repeat as necessary to configure a second trigger response.
CAN trigger responses
Trigger responses are only sent if the setting
Acknowledge/Send is not set to passive.
To test the transmission of a CAN response, click the
corresponding button.