User's Manual

Figure 9
3. LOADING THE PAPER
Gently pop the printer cover’s latch to open the cover (Figure 10); then lift the cover. Load a roll of
thermal paper (Appleton 1012 recommended) into the printer (Figure 11). Load it so that the
print-side of the paper will feed out facing the operator. Close the cover by pressing down evenly
on both side tabs, or by pressing on the center of the printer cover. Use the serrated bar to tear off
any excess paper.
Figure 10 Figure 11
4. USING THE MAGNETIC CARD READER
Magnetic Card Reader
Find the card reader slot at the right side of terminal. Slide the card in either direction through the
slot without stopping. If the card swipe fails, check the position of the magnetic stripe and slide
the card again (Figure 12).
Figure 12
5. USING THE KEY PAD
To enter numbers or letters, simply press the appropriate key. For example, to type the letter B:
Press and release [B] twice times, then display shows B (Figure 13).
Figure 13
6. INSTALLING THE SAM CARD
There are four SAM slots located on the left side of the device (Figure 14). Before insert the SAM
card, please turn off the device. Insert the SAM card in the slot in figure 15. Make sure SAM cards
inserted in the right direction (Figure 16).
Figure 14 Figure 15
7. INSTALLING THE PRIVACY SHIELD