User Manual

Federal Communications Commission Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the foll

owing two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that m

ay cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B d

igital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro

vide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if no

t installed and used in accordance with the instructions, may cause harmful interfe

rence to radio communications. However, there is no guarantee this equipment do

es not cause harmful interference to radio or TV reception. This can be determined

by turning the equipment on and off. The user is encouraged to try to correct the in

terference by one or more of the following measures:

z Reorient or relocate the receiving antenna.

z Increase the separation between the equipment and receiver.

z Connect the equipment into an outlet on a circuit different from that to whi

ch the receiver is connected.

z Consult the dealer or an experienced radio or television technician for hel

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS

EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USERS

AUTHORITY TO OPERATE THE EQUIPMENT.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment . End users must follow the specific operating

instructions for satisfying RF exposure compliance. To maintain compliance with

FCC RF exposure compliance requirements, please follow operation instruction as

documented in this manual.

For hand-held or desktop operation only. This PORTABLE TERMINAL meets

FCC RF exposure guidelines when used in hand-held or desktop operation.