TABLET POS HUB INSTALLATION GUIDE MODEL: TP72-HUB2
1. PACKAGE CONTAINS - TP72-HUB2. - Thermal paper. (Figure 1) Figure 1 2. PORT CONFIGURATION - There are several ports at the back side of TP72-HUB2. Support four USB host ports located on rear of left side. (Figure 3) Support one USB device port located on rear of right side. (Figure 4) Support one RS-232 ports of RJ-12 offset keyed connector. If TP72-HUB2 uses a peripheral device with this type of connector and interface, plug it into the RS-232 port on the back of the Cash drawer port (RJ11).
Operating Temperature: 0 C to 40 C. RTC battery spec. : 5V, CR2032. Power Adapter: Input rating: DC 24V, 4.17A (Use only the XAC Automation Corporation provided AC adapter approved for use with this device. Use of another AC adapter may cause a fire or explosion) 4. LOADING THE PAPER Gently press the “Open” button on the cover’s left side (Figure 10). Load a roll of thermal paper (Appleton 1012 recommended) into the TP72-HUB2.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
